понедељак, 15. фебруар 2016.

Body jig



                                                      

                                                       Picture says more than words.

 
Body

Tthe main part of the guides drills

One thing is certain, this tool you get a very practical   which can reverse many of the habits of 180 °.


  



Drilled holes at an angle of 15 degrees.  MDF strengthened by with plywood. 







    
Reinforcing guides the drill bit.

Angle drill for jig

I put an angle of 15 degrees. First I connected the two plywood, I cut off the tip at angles of 15 degrees and drilled hole. This part I used as a template for drilling the main part.



 

 The way of making pocket-hole connection and some application examples. This is achieved compound is about 35% stronger than standard connections "tongue and groove".

 Itself compound is, in essence, very simple. Boards to be joined is pressed against one another, either in the same plane, or in planes which are normal to each other, and an adjustment screw joints at an angle of 15 ° passes through both of the timber. If you immerse yourself in a bit of a problem, you will see that there are three key conditions need to be met:

- The screw must enter at a designated place,
- Angle of twist must be exactly 15 ° (result of having to compromise so as to render a compound with a stronger as long screw), and
- The screw must be accurate length and special constructions.

Planning preparation

In my country there are no tools when kreg pocket hole jig.
I decide to make this tool for my use.

Planning


I will show some pictures of how I was doing step by step.
 All shares in the village itself circular. Since the tool is only required drill presses.



 The tool is a very helpful for woodworker. For quick connecting of wood, MDF, plywood...