I put an angle of 15 degrees. First I connected the two plywood, I cut off the tip at angles of 15 degrees and drilled hole. This part I used as a template for drilling the main part.
The way of making pocket-hole connection and some application examples. This is achieved compound is about 35% stronger than standard connections "tongue and groove".
Itself compound is, in essence, very simple. Boards to be joined is pressed against one another, either in the same plane, or in planes which are normal to each other, and an adjustment screw joints at an angle of 15 ° passes through both of the timber. If you immerse yourself in a bit of a problem, you will see that there are three key conditions need to be met:
- The screw must enter at a designated place,
- Angle of twist must be exactly 15 ° (result of having to compromise so as to render a compound with a stronger as long screw), and
- The screw must be accurate length and special constructions.
The way of making pocket-hole connection and some application examples. This is achieved compound is about 35% stronger than standard connections "tongue and groove".
Itself compound is, in essence, very simple. Boards to be joined is pressed against one another, either in the same plane, or in planes which are normal to each other, and an adjustment screw joints at an angle of 15 ° passes through both of the timber. If you immerse yourself in a bit of a problem, you will see that there are three key conditions need to be met:
- The screw must enter at a designated place,
- Angle of twist must be exactly 15 ° (result of having to compromise so as to render a compound with a stronger as long screw), and
- The screw must be accurate length and special constructions.
Нема коментара:
Постави коментар